Physical Host Installation: Introduction

Document created by RSA Information Design and Development on Apr 10, 2019
Version 1Show Document
  • View in full screen mode
 

The instructions in this guide apply to physical hosts exclusively. See the RSA  Virtual Host Installation Guide for RSA NetWitness Platform 11.3 for instructions on how to set up virtual hosts in 11.3.

Go to the Master Table of Contents to find all NetWitness Platform Logs & Network 11.x documents.

Supported Hardware

Series 4, Series 4S, Series 5, and Series 6.

Refer to the RSA NetWitness Platform Hardware Setup Guides for detailed information on each series type (https://community.rsa.com/community/products/netwitness/hardware-setup-guides).

Endpoint Log Hybrid Host Hardware Specifications

Series 5 (Dell R730) hardware or Series 6 (Dell R740 hardware. See "(Optional) Task 2 - Install Endpoint Log Hybrid" in Post Installation Tasks for instructions on how to install the Endpoint Log Hybrid.

If you have RSA NetWitness® Endpoint 4.x hardware, you can re-purpose the same for NetWitness Endpoint Log Hybrid 11.3.

RSA NetWitness UEBA Host Hardware Specifications

S5 (Dell R630 appliance) or S6 (Dell R640) hardware. See "(Optional) Task 3 - Install NetWitness UEBA" in Post Installation Tasks for instructions on how to install NetWitness UEBA.

SERIES 5 (DELL R630) SPECIFICATIONS

                                                                                       
SpecificationCapacity
ModelDell PowerEdge R630xl
Processor TypeIntel Xeon E5 -2680v3

Processor Speed

Cache

Number of Cores

Number of Processors

Number of Threads

2.5 GHz

30MB

12

2

24

Total Memory256GB

Internal Disk Controller

Dell PERC H730

External Disk ControllerDell PERC H830

SAN Connectivity (HBA) - Optional

N/A

Remote Management CardiDRAC8 Enterprise

Drives

Total - 6 Drives

2 x 1TB, 2.5" HDD

4 x 2TB, 2.5" HDD

Chassis1U

Weight

18.4 kg (40.5 lbs)

NIC Card*

On Board

2 x 10 Gb Copper

2 x 10 Gb & 2 x 1Gb Copper

(Other options are available)

Dimensions

H: 4.28 cm (1.68 in.) x

W: 48.23 cm (18.98 in.)

x D: 75.51 cm (29.72 in.)

Power1100W Redundant

BTU/hr

4100 BTU/hr (max)

Amps (Spec)1100W / 220VAC = 5A

Actual Amp Draw (Post Startup)

2.1 Amps

Events Per Second (EPS)100K EPS

Throughput

N/A

* NIC Card options are available for swap with on-board daughter card or add on.

External Attached Storage

If you have an external storage device or devices (for example, DACs or PowerVaults) attached to a physical host, refer to the Hardware Setup Guides for information on how to configure this storage on RSA Link (https://community.rsa.com/community/products/netwitness/hardware-setup-guides)."

Physical Host Installation Workflow

The following diagram illustrates the RSA NetWitness® Platform 11.3 Physical Host Installation workflow.

Contact Customer Support

Refer to the Contact RSA Customer Support page (https://community.rsa.com/docs/DOC-1294) in RSA Link for instructions on how to get help on RSA NetWitness Platform 11.3.

You are here
Table of Contents > Introduction

Attachments

    Outcomes