RSA recommends that you stop network and log capture and aggregation before upgrading a Decoder, Concentrator, and Broker host to 11.3.0.2. If you do this, you must restart network and log capture and aggregation after updating these hosts.
Stop Data Capture and Aggregation
Stop Network Capture
- Log in to NetWitness Platform and go to ADMIN > Services.
The Services view is displayed. - Select each Decoder service.
- Under
(actions), select View > System.
- In the toolbar, click
.
Stop Log Capture
- Log in to NetWitness Platform and go to ADMIN > Services.
The Services view is displayed. - Select each Log Decoder service.
- Under
(actions), select View > System.
- In the toolbar, click
.
Stop Aggregation
- Log in to NetWitness Platform and go to ADMIN > Services.
- Select the Broker service.
- Under
(actions), select View > Config.
- The General tab is displayed.
- Under Aggregated Services click
.
Start Data Capture and Aggregation
Restart network and log capture and aggregation after updating to 11.3.0.2.
Start Network Capture
- Log in to NetWitness Platform and go to ADMIN > Services.
The Services view is displayed. - Select each Decoder service.
- Under
(actions), select View > System.
- In the toolbar, click
.
Start Log Capture
- Log in to NetWitness Platform and go to ADMIN > Services.
The Services view is displayed. - Select each Log Decoder service.
- Under
(actions), select View > System.
- In the toolbar, click
.
Start Aggregation
- Log in to NetWitness Platform and go to ADMIN > Services.
The Services view is displayed. - For each Concentrator and Broker service.
- Select the service.
- Select the service.
Previous Topic:Appendix A. Troubleshooting
You are here
Table of Contents > Appendix B. Stop Data Capture and Aggregation