Skip navigation
All Places > Products > RSA NetWitness Platform > RSA NetWitness Platform Online Documentation > Documents
Log in to create and rate content, and to follow, bookmark, and share content with other members.

Virtual Host Setup 11.5: Task 1. Add New Disk

Document created by RSA Information Design and Development Employee on Sep 9, 2020
Version 1Show Document
  • View in full screen mode
 

Get familiar with the RSA NetWitness Platform Storage Guide to understand the types of drives and volumes needed to support NetWitness instances. For more information, see Storage Guide for RSA NetWitness Platform 11.x

Add New Disk

Add New Disk in VMware ESXi

Add New Disk in Hyper-V

Add New Disk in VMware ESXi

This procedure shows you how to add a new 100 GB disk on the same datastore.

Note: The procedure to add a disk on different datastore is similar to the procedure shown here.

  1. Shut down the machine, edit Virtual Machine Properties, click Hardware tab, and click Add.

    Add

  2. Select Hard Disk as the device type.

    Hard disk as a device type

  3. Select Create a new virtual disk.

    create new virtual disk

  4. Choose the size of the new disk and where you want to create it (on the same datastore or a different datastore).

    Note: Choose data provisioning based on your requirements

    Thick provision eager zeroed

  5. Approve the proposed Virtual Device Node.

    Approve the proposed Virtual Device Node

    Note: The Virtual Device Node can vary, but it is pertinent to /dev/sdX mappings.

  6. Confirm the settings.

    Confirm the settings

Add New Disk in Hyper-V

  1. Shut down the VM and click Settings and IDE Controller, select the Hard Drive and click Add.

    Click Add

  2. Select the New Virtual Hard disk.

    Select New Virtual Hard disk

  3. Select VHDX as a disk format.

    Select VHDX as a disk format

  4. Select Dynamically expanding as a disk type.

    Select Dynamically expanding as  a disk type.

  5. Specify the Name and Location of the virtual hard disk file.

    Specify the Name and  Location of the virtual hard disk file

  6. Select create a new blank virtual hard disk and specify the size.

    create a new blank virtual hard disk

  7. In the Summary, review the settings and click Finish.

    Summary review


You are here
Table of Contents > Install NW Virtual Host in Virtual Environment > Step 2. Configure Databases to Accommodate NetWitness Platform > Task 1. Add New Disk

Attachments

    Outcomes