Archiver: Step 4. Add Workbench Service as a Data Source to Broker

Document created by RSA Information Design and Development on Apr 18, 2016
Version 1Show Document
  • View in full screen mode

Adding the Workbench service as a data source to Broker is useful when you have more than one collection and you want a report on the archived data. To do this, you can add more than one collection as a downstream service to a Broker and then generate a report on it. 


Ensure that you have:

  • Installed the Workbench service on the Archiver host.
  • Added a collection on the Workbench service.


To add a Workbench service as a data source on the Broker:

  1. In the Security Analytics menu, select Administration > Services.
  2. In the Services panel, select a Broker service.
  3. In the Actions column, select Actions menu cropped > View > Config.
    The Config view is displayed with the General tab open.
  4. In the Aggregate Services section, click add_icon.png.
    The Available Services dialog is displayed.
  1. Select the Workbench service and click OK.
  2. If the Workbench service is using a Trust Model, a Service Information dialog for the selected service is displayed.
  3. Type the username and password for admin credentials for the service.
  4. Click OK.
    The Add Collection dialog is displayed.
  5. Select a collection from the drop-down list and click OK.
    The Workbench service is now added as a data source to the Broker. 

Note: This procedure has to be performed for each collection.

You are here: Additional Procedures > Configure Data Backup and Restore > Step 4. Add Workbench Service as a Data Source to Broker