Decoder: Step 1. Verify System Configuration

Document created by RSA Information Design and Development on Apr 21, 2016
Version 1Show Document
  • View in full screen mode
 
  

This topic provides a procedure for verifying the system configuration of a Decoder or a Log Decoder.

When a service is first added to Security Analytics, default values for the system configuration parameters are in effect. You can edit these values to tune performance.

DecSysCfgSec.png

In most cases, the default values for compression, statistics update interval, and number of threads in the thread pool are set at a good point for optimal system performance. One parameter that you may want to change for your environment is the SSL setting, which by default is not enabled. When enabled, the security of data transmission is managed by encrypting information and providing authentication with SSL certificates.

Procedure

To edit system configuration parameters for a Decoder or Log Decoder:

  1. In the Security Analytics menu, select Administration > Services.
  2. In the Services view, select a Decoder or Log Decoder service, and select Actions menu cropped > View > Config.
    The Services Config view for the service is displayed with the General tab open.
  3. Under System Configuration, click in a field that you want to edit, and type a new value.
  4. When finished editing, click Apply.
You are here: Required Procedures > Step 1. Verify System Configuration

Attachments

    Outcomes