Warehouse: Add Stream Dialog

Document created by RSA Information Design and Development on Apr 28, 2016Last modified by RSA Information Design and Development on Apr 28, 2016
Version 2Show Document
  • View in full screen mode
 
  

This topic provides a description of the Add Stream dialog. In the Add Stream dialog, you can configure and add a stream to a Warehouse Connector.

To access this dialog:

  1. In the Security Analytics menu, select Administration > Services.
  2. In the Services view, select a Warehouse Connector service and select Actions menu cropped > View > Config.
  3. In the Streams tab, click ic-add.png.

    The Add Stream dialog is displayed.

     AddStream.png

For related procedures, refer to Create a Stream and Configure Warehouse Connector.

The following table describes the Add Stream dialog parameters.

                                       
ParameterDescription
Stream NameType the name of the stream. The stream name may only contain alphanumeric characters and underscores. It cannot exceed 20 characters in length.
Select DestinationSelect a destination from the drop-down list.
Select SourceSelect a source from the grid at the bottom section of the dialog.
NameThe name of the source.
AddressThe address of the source.
PortThe port of the source.
Session IDThe session ID of the source.
You are here: References > Add Stream Dialog

Attachments

    Outcomes