000032989 - How to show the Instrumentation step in the RSA Archer Installer after the Instrumentation service has already been installed

Document created by RSA Customer Support Employee on Jun 14, 2016Last modified by RSA Customer Support on May 1, 2019
Version 3Show Document
  • View in full screen mode

Article Content

Article Number000032989
Applies ToRSA Product Set: Archer
RSA Product Version: 5.5.3 and higher
IssueOnce the Archer Instrumentation service has been installed, the Archer Installer does not show the Instrumentation step.
  1. Browse to C:\Program Files\RSA Archer\Services\Instrumentation.
  2. Open the SemanticLogging-svc.xml file.
  3. On line 20, change the "connectionString" value to "***ConnectionStringShouldBeSetByInstaller***".
  4. Save changes and close file.
  5. Run the Archer Installer and notice the Instrumentation step is shown like a fresh install.