Article Content
Article Number | 000019581 |
Applies To | RSA ACE/Server 5.0 (no longer supported as of 8-15-2004) UNIX (AIX, HP-UX, Solaris) |
Issue | Upgrading RSA ACE/Server 5.0 to 5.0.1 |
Resolution | UNIX Procedure: 1. Stop all RSA ACE/Server processes, e.g. aceserver stop and sdconnect stop 2. Dump the database from the Primary ACE/Server, e.g. sddump -s 3. Copy the sdserv.dmp and license.rec files into a temporary directory (i.e. /dump) on the Primary ACE/Server system 4. Install the ACE/Server 5.0.1 software into a new directory structure (i.e. /opt/ace/501). RSA ACE/Server 5.0 UNIX Installation Guide (unix_install.pdf) provides more information on page 39, chapter titled "Installing the Primary Server for Primary ACE/Server installation instructions" 5. In the new ACEPROG directory run the following commands: sdnewdb, and enter all at the prompt sdload -s -u -f /dump/sdserv.dmp -k /dump/license.rec 6. Perform local and remote test authentications with both Primary and Replica running, and then with only the Replica running. If these tests are successful, you have a working RSA ACE/Server 5.0.1 Primary server. NOTE: If you are using a TACACS deamon, do not forget to configure this using the sdsetup -config command |
Legacy Article ID | a10566 |