000024961 - Authenticate through an IBM Secureway Firewall

Document created by RSA Customer Support Employee on Jun 14, 2016Last modified by RSA Customer Support Employee on Apr 21, 2017
Version 2Show Document
  • View in full screen mode

Article Content

Article Number000024961
Applies ToIBM Secureway Firewall
RSA ACE/Server
UNIX (AIX, HP-UX, Solaris)
IBM Secureway Firewall with two interface cards
IssueAuthenticate through an IBM Secureway Firewall
When authenticating through the IBM Secureway Firewall, passcode incorrect appears in the ACE/Server logs, and there is a prompt for another passcode on the firewall.
ResolutionBring up sdadmin on the Master server, or open up a remote administration session.

Delete the current client that you have defined for the IBM Secureway Firewall.

Make a new client for the IBM Secureway Firewall making the outside interface of the firewall the primary interface for the client.

Define the inside interface in the secondary node area of the client setup screen.

It should be noted that this may not always be the case. Secondary nodes must be defined. At times you might have to change the order for the Primary to Secondary nodes in order to get the proper configuration.
Legacy Article IDa96