000023869 - SID - After changing token records with the 'setsyncint' utility  do you need to generate a new replica package for a replica?

Document created by RSA Customer Support Employee on Jun 16, 2016Last modified by RSA Customer Support Employee on Apr 21, 2017
Version 2Show Document
  • View in full screen mode

Article Content

Article Number000023869
Applies ToRSA Authentication Manager 6.x
IssueSID - After changing token records with the "setsyncint" utility, do you need to generate a new replica package for a replica?
"setsyncint" is an RSA Support-supplied utility to change token offsets and modes
ResolutionYou do NOT need to generate a new replica package for setsyncint changes to propagate to the replica(s). Performing the steps below with automatically get changes to the replica.

stop the primary
run setsyncint (for instance, to take tokens out of new-pin mode)
start the primary
wait a replication time interval to pass  (normally up to 100 seconds)
connect to the replica with Remote Admin and confirm the change (Remote Admin; Token, View Token, would show a token in or out of new-pin mode)
Legacy Article IDa35737

Attachments

    Outcomes