Warehouse: Step 7. Configure Streams

Document created by RSA Information Design and Development on Jul 25, 2016
Version 1Show Document
  • View in full screen mode

This topic describes the tasks to configure the data stream to define the data source and destination combinations.


Make sure that you have:

  • Installed the Warehouse Connector service or virtual appliance in your network environment.
  • Added the Warehouse Connector service to Security Analytics. For more information, see the Add a Service to a Host topic in the Hosts and Services Getting Started Guide.
  • Configured the data source form which the Warehouse Connector service needs to collect data. For more information, see Step 3. Configure the Data Source.
  • Configured the destination to which the Warehouse Connector service needs to write the collected data. For more information, see Configure the Destination.


To configure the stream:

1. Create a streamRefer to Create a Stream.
2. Finalize the streamRefer to Finalize the Stream.
3. Start the streamRefer to Start the Stream.




You are here: Configure Warehouse Connector > Warehouse: Step 7. Configure Streams