Configuring the Warehouse Connectoer monitoring enables you to automatically generate notification when critical thresholds concerning Warehouse Connector and storage have been met.
Access the Warehouse Connector Monitoring view
- In the Security Analytics menu, select Administration > Health & Wellness.
Select Settings > Warehouse Connector.
The Warehouse Connector Monitoring view is displayed.
Warehouse Connector Monitoring parameters
The following table lists the parameters required to configure the Warehouse Connector to automatically generate notification when critical thresholds are reached.
|Source or Destination Status||Notify Offline For||Number of minutes or hours after which the you will receive a notification if the source or destination connection fails.|
|Stream Status||Notify Stopped For||Number of minutes or hours after which you would like to receive a notification when the Stream goes offline.|
|Disk Is||The limit on the percentage of disk usage after which you would like to receive a notification.|
|Source Is Behind||Number of sessions after which a notification is raised if the source goes behind the defined number of sessions.|
|Rejected Folder Size Is||Limit on the percentage of folder usage after which you would like to receive a notification.|
|Number Of Files in Permanent Failure Folder||Limit on the number of files in the permanent failure folder after which you would like to receive a notification.|
|Notification Type||Configure email or distribution list||Click to configure email so that you can receive notifications in Security Analytics.|
|Configure Syslog and SNMP Trap servers||Click to configure audit logs.|
Syslog Notification, SNMP Trap Notification
|Enable SA Console to get notifications on the Security Analytics UI notification toolbar.|
Enable Email to get email notifications.
Enable Syslog Notification to generate syslog events.
Enable SNMP Trap Notification to get audit events as SNMP traps.