Log Collection Legacy Windows: Procedures

Document created by RSA Information Design and Development on Jul 29, 2016
Version 1Show Document
  • View in full screen mode
 

Configuration steps for Log Collector must occur in the specific sequence listed in the table below.

Legacy Windows and NetApp Configuration Checklist

Note: You install the Security Analytics Legacy Windows Collector on a physical or virtual Windows 2008 R2 SP1 64-Bit server using the SALegacyWindowsCollector-version-number.exe. You download the SALegacyWindowsCollector-version-number.exe from SCOL [please refer to the SA-v10.5 Legacy Windows Upgrade and Installation Instructions on SCOL  (https://knowledge.rsasecurity.com/)].

The steps in this list are in the order in which you must complete them.

                         

Step

Description

checkmark.PNG

1

Set up your Legacy Windows collector.

 

2

Configure Windows Legacy Event Sources in Security Analytics.

 

3

Start service for configured Legacy Windows protocol.

 

4

Verify that Windows Legacy Collection is working.

 
You are here: Legacy Windows and NetApp Collection Configuration Guide > Log Collection Legacy Windows: Procedures

Attachments

    Outcomes