Reporting: View a Report Panel

Document created by RSA Information Design and Development on Jul 29, 2016
Version 1Show Document
  • View in full screen mode

The View a Report panel is used to review the reports.


The View a Report panel has the following sections:

  • Reports toolbar
  • Reports Output panel
  • Reports Calendar panel
  • Reports Time panel

The following figure shows the View Scheduled Reports.


When you click View on the scheduled report having Iterative selected, the Sub Reports panel is displayed. For each value in the configured list a report is generated.


The following table lists the various columns in the Sub Reports panel.

Column   Description
ValuesThe List values chosen for a dynamic variable from the List Selection panel.
StateIndicates the state of the scheduled report for each of the list values.
  • Partial: If in a report with several rules, a single rule execution failed or an output action failed or creation of PDF/CSV failed, the state of the report is displayed as partial. For example, consider a report with five rules and four rules are executed successfully and one fails, then the state is displayed as Partial.
  • Failed: If in a report with several rules, all the rule executions failed, the state of the report is displayed as failed.
  • Completed: If a report is successfully executed, the state of the report is displayed as completed.
ViewClick to view the report.

Note: You can view the completed rules on the View a Report page even when the report is 'running'.

Click on any of the report schedules or sub reports listed and click View to view the desired report.

For more information, on each of these panels, see View All Reports Panel.

You are here: Reporting Module References > Report References > View a Report Panel