Warehouse Connector: Step 7: Configure Streams

Document created by RSA Information Design and Development on Jul 31, 2016
Version 1Show Document
  • View in full screen mode
 

This topic describes the tasks to configure the data stream to define the data source and destination combinations.

Prerequisites

Make sure that you have:

  • Installed the Warehouse Connector service or virtual appliance in your network environment.
  • Added the Warehouse Connector service to Security Analytics. For more information, see Add a Service to a Host in the Getting Started Guide.
  • Configured the data source form which the Warehouse Connector service needs to collect data. For more information, see Step 3: Configure the Data Source.
  • Configured the destination to which the Warehouse Connector service needs to write the collected data. For more information, see Step 4: Configure the Destination Using NFS

Procedure

To configure the stream:

                
TasksReferences
1. Create a streamRefer to Create a Stream
2. Finalize the streamRefer to Finalize the Stream.
3. Start the streamRefer to Start the Stream.
You are here: Configure Warehouse Connector > Warehouse Connector: Step 7: Configure Streams

Attachments

    Outcomes