Warehouse Connector: Create a Stream

Document created by RSA Information Design and Development on Jul 31, 2016
Version 1Show Document
  • View in full screen mode

To create a stream:

  1. In the Security Analytics menu, select Administration > Services.
  2. In the Services view, select the added Warehouse Connector service and Actions menu cropped > View > Config.
    The Services Config view of Warehouse Connector is displayed.
  3. Click the Streams tab.
  4. On the Streams tab, click add_icon.png.
  5. In the Add Stream dialog, perform the following:
    1. In the Stream Name field, enter a name for the stream.

      Note: The Stream Name field does not support space or special characters except underscore (_).

    2. In the Select Destination drop-down menu, select a destination from the list of destinations added to the Warehouse Connector.
    3. In the Select Source field, select sources from the list of sources displayed.
    4. In the Session ID column, enter the last session id.
      If you provide any session id, the Warehouse Connector will start the aggregation from that session, whereas if this is left blank, the aggregation will start from the current session.
    5. Click Save.

Next Steps

Perform the following tasks:

  1. Finalize the stream. For more information, see Finalize the Stream.
  2. Start the stream. For more information, see Start the Stream.
You are here: Configure Warehouse Connector > Step 7: Configure Streams > Create a Stream