Virtual Host Setup: Step 4. Configure Host-Specific Parameters

Document created by RSA Information Design and Development on Dec 20, 2016Last modified by RSA Information Design and Development on Aug 29, 2017
Version 5Show Document
  • View in full screen mode
  

Certain application-specific parameters are required to configure log ingest and packet capture in the Virtual Environment.

Configure Log Ingest in the Virtual Environment

Log ingest is easily accomplished by sending the logs to the IP address you have specified for the Decoder. The Decoder's management interface allows you to then select the proper interface to listen for traffic on if it has not already selected it by default.

Configure Packet Capture in the Virtual Environment

There are two options for capturing packets in a VMWare environment. The first is setting your vSwitch in promiscuous mode and the second is to use a third-party Virtual Tap.

Set a vSwitch to Promiscuous Mode

The option of putting a switch whether virtual or physical into promiscuous mode, also described as a SPAN port (Cisco services) and port mirroring, is not without limitations. Whether virtual or physical, depending on the amount and type of traffic being copied, packet capture can easily lead to over subscription of the port, which equates to packet loss. Taps, being either physical or virtual, are designed and intended for loss less 100% capture of the intended traffic.

Promiscuous mode is disabled by default, and should not be turned on unless specifically required. Software running inside a virtual machine may be able to monitor any and all traffic moving across a vSwitch if it is allowed to enter promiscuous mode as well as causing packet loss due to over subscription of the port..

To configure a portgroup or virtual switch to allow promiscuous mode:

  1. Log on to the ESXi/ESX host or vCenter Server using the vSphere Client.
  2. Select the ESXi/ESX host in the inventory.
  3. Select the Configuration tab.
  4. In the Hardware section, click Networking.
  5. Select Properties of the virtual switch for which you want to enable promiscuous mode.
  6. Select the virtual switch or portgroup you want to modify, and click Edit.
  7. Click the Security tab. In the Promiscuous Mode drop-down menu, select Accept.

Use of a Third-Party Virtual Tap

Installation methods of a virtual tap vary depending on the vendor. Please refer to the documentation from your vendor for installation instructions. Virtual taps are typically easy to integrate, and the user interface of the tap simplifies the selection and type of traffic to be copied.

Virtual taps encapsulate the captured traffic in a GRE tunnel. Depending on the type you choose, either of these scenarios may apply:

  • An external host is required to terminate the tunnel, and the external host directs the traffic to the Decoder interface.
  • The tunnel send traffic directly to the Decoder interface, where Security Analytics handles the de-encapsulation of the traffic.
You are here
Table of Contents > Install SA Virtual Host in Virtual Environment > Step 4. Configure Host-Specific Parameters

Attachments

    Outcomes