Archiver: Step 3. Add Workbench Service as Data Source to Reporting Engine

Document created by RSA Information Design and Development on Mar 21, 2017Last modified by RSA Information Design and Development on Mar 24, 2017
Version 5Show Document
  • View in full screen mode
  

This topic provides instructions on how to add the Workbench service as a data source to Reporting Engine to generate reports for the data restored onto the Archiver.

Prerequisites

Ensure that you have:

  1. Installed the Workbench service on the Archiver host.
  2. Added a collection on the Workbench service.

Procedure

Perform the following steps to add the Workbench service as a data source to Reporting Engine:

  1. In the Security Analytics menu, select Administration > Services.
  2. In the Services panel, select a Reporting Engine service.
  3. In the Actions column, select View > Config.
  4. Select the Sources tab.
  5. Click add_icon.png and select Available Services.
    The Available Services dialog is displayed.
    add_wb_service.png
  6. Select the Workbench service and click OK.
    If the Workbench service is using a Trust Model, the Service Information dialog for the selected service is displayed with the username and password fields required. If the service is not using a Trust Model, these fields will be optional.
    SrvInfoWB.png
  7. Type the username and password for admin credentials for the service.
  8. Click OK.
    The Add Collection dialog is displayed.
    add_wb_service_collection_dialog.png
  9. Select a collection from the drop-down list and click OK.
    The Workbench service is now added as a data source to the Reporting Engine and is listed in the NWDB Data Sources list. 

Note: This procedure has to be performed for each collection.

You are here
Table of Contents > Additional Procedures > Configure Data Backup and Restore > Step 3. Add Workbench Service as Data Source to Reporting Engine

Attachments

    Outcomes