Host GS: Set Network Configuration

Document created by RSA Information Design and Development Employee on Mar 21, 2017
Version 1Show Document
  • View in full screen mode

When a configured Core host needs its address changed, you can set a new network address, subnet mask, and gateway for the host using the Set Network Configuration message in the Host Task List

Caution: The change goes into effect immediately, and the host is disconnected from Security Analytics. You must then add the host to Security Analytics again using the new network address.

Specify the Network Address for a Host

  1. In the Security Analytics menu, select Administration >Services.
  2. In the Services grid, select a service and Actns.png > View> System
    The System view for the service is displayed.
  3. In the Services System view toolbar, click Host Tasks.
  4. In the Host Task List, click Set Network Configuration.
    The task is displayed in the Task field and help is displayed in the Info area.

  5. Enter the arguments in the Arguments field. For example:
    mode=static address= netmask= gateway=
  6. Click Run.
    The task executes and the result is displayed in the Output area. The host is disconnected from Security Analytics. You must add the host again with the new address.

Note: If the mode is DHCP, there may be no way to determine the new address. You may have to connect to the host directly to determine the new address.

You are here
Table of Contents > Host Procedures from the Task List Dialog > Set Network Configuration