SA Cfg: Output Tab

Document created by RSA Information Design and Development Employee on Mar 22, 2017Last modified by RSA Information Design and Development Employee on Sep 26, 2017
Version 2Show Document
  • View in full screen mode

This topic describes the components of the Global Notifications > Output tab. This tab enables you to configure notification outputs. Global Notifications configurations define notifications settings for Event Source Management (ESM), Health and Wellness, Global Audit Logging, Event Stream Analysis (ESA), and Incident Management. 

Notification Output configurations define email addresses and subject lines, SNMP trap OID settings, syslog output settings, and script code.

Notifications are the destinations configured for the alert notifications that are sent by ESA service. You can configure the following as destinations using the Output tab:

  • Email
  • SNMP
  • Syslog 
  • Script

Note: You do not need to configure the Output tab for Global Audit Logging. For detailed steps, see Configure Global Audit Logging

The following figure shows the Global Notifications > Output tab:

On the Output tab, you can perform the following:

  • Configure the Email settings as notification.
  • Configure SNMP settings as notification.
  • Configure Syslog settings as notification.
  • Configure a Script as notification.

For detailed instructions, see Configure Notification Outputs.

Next Topic:Servers Tab
You are here
Table of Contents > References > Global Notifications Panel > Output Tab