Workbench: Add Workbench Service as a Data Source to Broker

Document created by RSA Information Design and Development on Mar 22, 2017
Version 1Show Document
  • View in full screen mode


Before adding the Workbench service, you must:

  • Install the Workbench service on the Archiver appliance.
  • Add a collection on the workbench service.

To add the Workbench service as a data source on the Broker:

  1. In the Security Analytics menu, select Administration >Services.
  2. Select a Broker service, and select Actns.png > View > Config.
    The Service Config view is displayed.
  3. Select the General tab.
  4. Click add_icon.png and select Available Services.
    The Available Services dialog is displayed.
  5. Select the Workbench service and click OK.
  6. If the Workbench service is using a Trust Model, a Service Authentication dialog for the selected service is displayed.
  7. Type the username and password for admin credentials for the service.
  8. Click OK.
    The Add Collection dialog is displayed.
  9. Select a collection from the drop-down list and click OK.
    The workbench service is now added as a data source to the Broker and is listed in the NWDATA Sources list. 

Note: This procedure has to be performed for each collection.

You are here
Table of Contents > Configuration Procedures > Add Workbench Service as a Data Source to Broker