This topic provides instructions for configuring the nodes for the RSA Analytics Warehouse (MapR). It only applies to RSA Analytics Warehouse instances running MapR.
Prerequisites
Make sure that you have:
- Installed the RSA Analytics Warehouse (Warehouse) appliance in your network environment. For more information, see the RSA Analytics Warehouse (MapR) Setup Guide in the Hardware Setup guides.
- Configured the network interface of the Warehouse appliance.
Procedure
Perform the following procedures in the order shown to set up Warehouse. If you are planning to have a cluster of Warehouse appliances, make sure that you perform the following tasks on all the appliances in the cluster.
Caution: Prerequisites are mandatory. Your installation will fail if you have not set the network configuration as described in the RSA Analytics Warehouse (MapR) Setup Guide or Virtual Host Setup Guide depending on your deployment.
Post Configuration Steps
The following table lists the optional tasks that you can perform after configuring the Warehouse: