MapR: Step 6. Configure the Connector to Write to Warehouse

Document created by RSA Information Design and Development on Jun 22, 2017
Version 1Show Document
  • View in full screen mode
  

This topic provides instructions for enabling the services to write to RSA Analytics Warehouse.

Procedure

To configure Warehouse Connector to write to the Warehouse, perform the following tasks on the Log Decoders and Decoders where the Warehouse Connectors are installed:

Note: If you are configuring on a virtual environment, perform these tasks on a standalone Warehouse Connector server.

                     
TasksReferences
  1. Verify the Network File System (NFS) Services status.
Refer to Verify the Network File System (NFS) Services Status
  1. Install the NFS services package.
Refer to Install the Network File System Packages.
  1. Mount RSA Analytics Warehouse on the appliance where you have installed the Warehouse Connector service.
Refer to Mount the Warehouse on the Warehouse Connector.
You are here
Table of Contents > Configure RSA Analytics Warehouse (MapR) > Step 6. Configure the Connector to Write to Warehouse

Attachments

    Outcomes