This topic provides an overview of the Warehouse Connector Services Config view. The tabs for a Warehouse Connector in the Services Config view provide a way to manage basic service configuration, configure sources, configure destination, and configure streams.
The following are the tabs in the Warehouse Connector Services Config view:
- Sources and Destinations
- Lockbox Settings
- Appliance Service Configuration
Sources and Destinations
The Sources and Destinations tab contains the following two sections:
- Source Configuration
- Destination Configuration
The Source Configuration section allows you to configure the data sources form which the Warehouse Connector service needs to collect data.
The following is an example of the Source Configuration section.
The Source Configuration section allows you to perform the following.
The Destination Configuration section allows you to configure the destination to which the Warehouse Connector service needs to write the collected data.
The Destination Configuration section allows you to perform the following.
The Streams tab allows you to perform all of the tasks related to a stream.
The Streams tab allows you to perform the following.
The Streams tab also lists all the created streams in a tabular format.
The following parameters are displayed in the Stream Statistics.
Change Stream Configuration
You can change configuration of a stream in runtime. In the Streams tab, click Change Configuration to change the configuration of the selected stream.
You can change the following parameters of the Stream Configuration:
After upgrading, if the values of Maximum Message Hold Count, Maximum Message Hold Interval and Maximum Message Hold Size are 3000000, 60 and 128 respectively, ensure that you assign the following values to the streams:
Maximum Message Hold Count - 2400000
Maximum Message Hold Interval - 600
Maximum Message Hold Size - 512
The Lockbox Settings tab allows you can set, change, or refresh the lockbox password of the Warehouse Connector.
The General tab displays the system configuration parameters for the Warehouse Connector service.
When you add a Warehouse Connector service, default values are in effect. RSA designed the default values to accommodate most environments and recommends that you do not edit these values because it may adversely affect performance. The following table describes the System Configuration parameters.
Appliance Service Configuration
The Appliance Service Configuration tab displays the appliance configuration settings for Warehouse Connector service. For more information, see the Appliance Service Configuration topic in the Hosts and Services Getting Started Guide.