Skip navigation
All Places > Products > RSA NetWitness Platform > RSA NetWitness Platform Online Documentation > Documents
Log in to create and rate content, and to follow, bookmark, and share content with other members.

Workbench: Add Workbench Service as a Data Source to Broker

Document created by RSA Information Design and Development on Sep 14, 2017Last modified by RSA Information Design and Development on Jan 30, 2020
Version 10Show Document
  • View in full screen mode
 

Prerequisites

Before adding the Workbench service, you must:

  • Install the Workbench service on the Archiver appliance.
  • Add a collection on the workbench service.

To add the Workbench service as a data source on the Broker:

  1. Go to Admin >Services.
  2. Select a Broker service, and select  > View > Config.
    The Service Config view is displayed with General tab open.
    Service Config View is displayed.
  3. In the Aggregate Services section, Click 

    The Available Services dialog is displayed.

    Example of Available Services dialog with the Workbench selected.

  4. Select the Workbench service and click OK.
  5. If the Workbench service is using a Trust Model, a Service Authentication dialog for the selected service is displayed.

    Example of Service Authentication dialog for the selected service.

  6. Type the username and password for admin credentials for the service and click OK.

    The Add Service Workbench dialog is displayed.

    Example of the Add Service Workbench dialog.

  7. Type the username and password for admin credentials for the service and click OK.

    The workbench service is now added as a data source to the Broker and is listed in the NWDATA Sources list. 

Note: You must perform this procedure for each collection.

You are here
Table of Contents > Configuration Procedures > Add Workbench Service as a Data Source to Broker

Attachments

    Outcomes