Skip navigation
All Places > Products > RSA NetWitness Platform > RSA NetWitness Platform Online Documentation > Documents
Log in to create and rate content, and to follow, bookmark, and share content with other members.

Warehouse Connector: Configure

Document created by RSA Information Design and Development Employee on Sep 14, 2017Last modified by RSA Information Design and Development Employee on Sep 4, 2020
Version 15Show Document
  • View in full screen mode

You can configure the Warehouse Connector service using the following procedure.

To set the Lockbox password:

  1. Log on to NetWitness Platform.
  2. Go to  (Admin) > Services.
  3. In the Services view, select the added Warehouse Connector service, and select  > View > Config.

  4. In the Services Config view of Warehouse Connector, click the Lockbox Settings tab.

    Lockbox setting in Service config 

  5. In the Create New Lockbox section, perform the following:

    1. In the Lockbox Password field, enter the new lockbox password.

      Note: The lockbox password must be at least eight characters in length and it must contain at least three of the following groups: one uppercase character [A-Z], one lowercase character [a-z], one numeral [0-9], and one special character.

    2. In the Confirm Lockbox Password field, enter the added lockbox password to confirm.
    3. Click Apply.
  6. The Lockbox password is set.

You are here
Table of Contents > Configure a Warehouse Connector Service