Skip navigation
All Places > Products > RSA NetWitness Platform > RSA NetWitness Platform Online Documentation > Documents
Log in to create and rate content, and to follow, bookmark, and share content with other members.

Warehouse Connector: Install Warehouse Connector Service on a Log Decoder or Decoder

Document created by RSA Information Design and Development Employee on Sep 14, 2017Last modified by RSA Information Design and Development Employee on Sep 4, 2020
Version 15Show Document
  • View in full screen mode
 

To install (fresh install) the Warehouse Connector service on a Log Decoder or Decoder or Hybrid:

  1. Log in to NW Admin server
  2. Enter the following command on NetWitness Server:
    warehouse-installer --help
    The command line interface (CLI) usage descriptions are displayed.
  1. Install Warehouse Connector service by executing the following command:
    warehouse-installer --host-key <ID, IP address, hostname or display name of Decoder, Log Decoder, or Hybrid host>
  2. Restart the Warehouse Connector using following command:
    service nwwarehouseconnector restart

The Warehouse Connector service is successfully installed on the Log Decoder or Decoder or Hybrid.

Note: If you have custom-defined host entries in /etc/hosts, make sure to have the same entires in /etc/hosts.user. Run the following command to ensure that the host names are updated in this installation:
nw-manage --refresh-host --host-key <ID, IP, hostname or display name of host>
For more information, see "Manage Custom Host Entries in /etc/hosts" in the System Maintenance Guide.

You are here
Table of Contents > Install Warehouse Connector Service on a Log Decoder or Decoder

Attachments

    Outcomes