You can configure and add a stream to a Warehouse Connector in this dialog
|Role||I want to...||Refer to...|
|Administrator||Install Warehouse Connector Service on a Log Decoder or Decoder||Install Warehouse Connector Service on a Log Decoder or Decoder or Hybrid|
|Administrator||Configure a Warehouse Connector Service||Configure a Warehouse Connector Service|
|Administrator||Configure the Data Source for Warehouse Connector||Configure the Data Source for Warehouse Connector|
Configure the Destination using NFS, SFTP, WebHDFS.
|Administrator||Configure a Stream*||Configure a Stream|
|Administrator||Monitor a Warehouse Connector||Monitor a Warehouse Connector|
Add Warehouse as Data Source to Reporting Engine
For more information, see "Add Warehouse as a Data Source to Reporting Engine" in the Reporting Engine Configuration Guide.
|Administrator||Analyze a Warehouse Report||For more information, see "Step 4. Analyze a Warehouse Report" in the Warehouse Guide.|
Manage a Stream and Lockbox
*You can perform this task in the current view
The following figure is an example with the important features labeled.
|1||Go to (Admin) > Services.|
|2||In the services view, select a Warehouse Connector service and select >view>config|
The following table describes the fields in the Add Stream dialog:
|Stream Name||Type the name of the stream. The stream name may only contain alphanumeric characters and underscores. It cannot exceed 20 characters in length.|
|Select Destination||Select a destination from the drop-down list.|
|Select Source||Select a source from the grid at the bottom section of the dialog.|
|Name||The name of the source.|
|Address||The address of the source.|
|Port||The port of the source.|
|Session ID||The session ID of the source.|