Skip navigation
All Places > Products > RSA NetWitness Platform > RSA NetWitness Platform Online Documentation > Documents
Log in to create and rate content, and to follow, bookmark, and share content with other members.

Warehouse Connector: General Tab Settings

Document created by RSA Information Design and Development Employee on Sep 14, 2017Last modified by RSA Information Design and Development Employee on Sep 4, 2020
Version 15Show Document
  • View in full screen mode

The General tab displays the general configuration settings for Warehouse Connector service.


General tab settings workflow

What do you want to do?

RoleI want to...Refer to...
AdministratorInstall Warehouse Connector Service on a Log Decoder or DecoderInstall Warehouse Connector Service on a Log Decoder or Decoder or Hybrid
AdministratorConfigure a Warehouse Connector Service*Configure a Warehouse Connector Service
AdministratorConfigure the Data Source for Warehouse ConnectorConfigure the Data Source for Warehouse Connector


Configure the Destination using NFS, SFTP, WebHDFS.

Configure the Destination Using NFS

Configure the Destination Using SFTP

Configure the Destination Using WebHDFS

AdministratorConfigure a StreamConfigure a Stream
AdministratorMonitor a Warehouse ConnectorMonitor a Warehouse Connector


Add Warehouse as Data Source to Reporting Engine

For more information, see "Add Warehouse as a Data Source to Reporting Engine" in the Reporting Engine Configuration Guide.

AdministratorAnalyze a Warehouse ReportFor more information, see "Step 4. Analyze a Warehouse Report" in the Warehouse Guide.


Manage a Stream and Lockbox

Manage a Stream

*You can perform this task in the current view

Related topics

Quick Look

The following figure shows the General tab on the Warehouse Connector Services Config view.

The General tab displays the system configuration parameters for the Warehouse Connector service.

General tab settings in system config view

When you add a Warehouse Connector service, default values are in effect. RSA designed the default values to accommodate most environments and recommends that you do not modify these values because it may adversely affect performance.

The following table describes the System Configuration parameters:

NameConfig Value
CompressionDetermines the minimum amount of bytes before a message is compressed. If set to zero, messages are not compressed.
PortDetermines the port used by the service.

Note: If you change the port number, ensure that you restart the service.

SSLIf enabled, all the data transferred in the network will be encrypted using SSL.
Stat Update IntervalDetermines how often (in milliseconds) statistic nodes are updated in the system.
ThreadsDetermines the number of threads in the thread pool to handle incoming requests.

Previous Topic:Warehouse Connector Configuration References
You are here
Table of Contents > Warehouse Connector Configuration References > General Tab Settings