You must configure the nodes for the RSA NetWitness Warehouse (MapR). It only applies to RSA NetWitness Warehouse instances running MapR.
Prerequisites
Make sure that you have:
- Installed the RSA NetWitness Warehouse appliance in your network environment. For more information, see "RSA Analytics Warehouse (MapR) Setup Guide" in the Hardware Setup guides.
- Configured the network interface of the Warehouse appliance.
This figure is an overview of the entire process of configuring Warehouse appliance in your network.
To configure the nodes for the RSA NetWitness Warehouse (MapR), perform the following:
Note: If you are planning to have a cluster of Warehouse appliances, make sure you perform the following tasks on all the appliances in the cluster.
Caution: Prerequisites are mandatory. Your installation will fail if you have not set the network configuration as described in the RSA Analytics Warehouse (MapR) Setup Guide or Virtual Host Setup Guide depending on your deployment.
Previous Topic:RSA NetWitness Warehouse Overview
Next Topic:Configure MapR
You are here
Table of Contents > How Warehouse (MapR) Works