Adding Workbench Service as a Data Source to Broker

Prerequisites

Before adding the Workbench service, you must:

  • Install the Workbench service on the Archiver appliance.
  • Add a collection on the workbench service.

To add the Workbench service as a data source on the Broker:

  1. Go to netwitness_adminicon_25x22.png (Admin) > Services.
  2. Select a Broker service, and select netwitness_actions_icon.png > View > Config.
    The Service Config view is displayed with General tab open.
    Service Config View is displayed.
  3. In the Aggregate Services section, Click netwitness_add_icon.png.

    The Available Services dialog is displayed.

    Example of Available Services dialog with the Workbench selected.

  4. Select the Workbench service and click OK.
  5. If the Workbench service is using a Trust Model, a Service Authentication dialog for the selected service is displayed.

    Example of Service Authentication dialog for the selected service.

  6. Type the username and password for admin credentials for the service and click OK.

    The Add Service Workbench dialog is displayed.

    Example of the Add Service Workbench dialog.

  7. Type the username and password for admin credentials for the service and click OK.

    The workbench service is now added as a data source to the Broker and is listed in the NWDATA Sources list.

Note: You must perform this procedure for each collection.