Appliance Service Configuration Tab Settings

The Appliance Service Configuration tab displays the appliance configuration settings for Warehouse Connector service. For more information, see "Appliance Service Configuration" in the Hosts and Services Getting Started Guide.

Workflow

General tab settings workflow

What do you want to do?

Role I want to... Refer to...
Administrator Install Warehouse Connector Service on a Log Decoder or Decoder Install Warehouse Connector Service on a Log Decoder or Decoder or Hybrid
Administrator Configure a Warehouse Connector Service* Configure a Warehouse Connector Service
Administrator Configure the Data Source for Warehouse Connector Configure the Data Source for Warehouse Connector

Administrator

Configure the Destination using NFS, SFTP, WebHDFS.

Configure the Destination Using NFS

Configure the Destination Using SFTP

Configure the Destination Using WebHDFS

Administrator Configure a Stream Configure a Stream
Administrator Monitor a Warehouse Connector Monitor a Warehouse Connector

Administrator

Add Warehouse as Data Source to Reporting Engine

For more information, see "Add Warehouse as a Data Source to Reporting Engine" in the Reporting Engine Configuration Guide.

Administrator Analyze a Warehouse Report For more information, see "Step 4. Analyze a Warehouse Report" in the Warehouse Guide.

Administrator

Manage a Stream and Lockbox*

Manage a Stream

*You can perform this task in the current view

Related topics

Quick Look

The following figure shows the different settings on the Appliance Service Configuration tab.

Appliance service configuration in service config view

When you add a Warehouse Connector service, default values are in effect. RSA designed the default values to accommodate most environments and recommends that you do not edit these values because it may adversely affect performance.

The following table describes the Appliance Service Configuration parameters:

Name Configuration Value
Compression Determines the minimum amount of bytes before a message is compressed. If set to zero, messages are not compressed.
Port Determines the port used by the service.

Note: If you change the port number, ensure that you restart the service.

SSL FIPS Mode If enabled, all the data transferred in the network will be encrypted using SSL FIPS.
SSL Port Determines the SSL port used by the service.
Stat Update Interval Determines how often (in milliseconds) statistic nodes are updated in the system.
Threads Determines the number of threads in the thread pool to handle incoming requests.