Install Warehouse Connector Service on a Log Decoder or Decoder or HybridInstall Warehouse Connector Service on a Log Decoder or Decoder or Hybrid
To install (fresh install) the Warehouse Connector service on a Log Decoder or Decoder or Hybrid:
- Log in to NW Admin server
- Enter the following command on NetWitness Server:
The command line interface (CLI) usage descriptions are displayed.
- Install Warehouse Connector service by executing the following command:
warehouse-installer --host-key <ID, IP address, hostname or display name of Decoder, Log Decoder, or Hybrid host>
- Restart the Warehouse Connector using following command:
service nwwarehouseconnector restart
The Warehouse Connector service is successfully installed on the Log Decoder or Decoder or Hybrid.
Note: If you have custom-defined host entries in /etc/hosts, make sure to have the same entires in /etc/hosts.user. Run the following command to ensure that the host names are updated in this installation:
nw-manage --refresh-host --host-key <ID, IP, hostname or display name of host>
For more information, see "Manage Custom Host Entries in /etc/hosts" in the System Maintenance Guide.