Logging Attached NAS Celerra 3500
RSA EnVision does have 2 Interface
1x versus General Network
1x versus Storage Network (own Switch)
I did configure the Celerra NAS like it is reccomended by the Manual Page.
as destination i did use the IP Of the Storage Network interface.
Should this work?
Another Smal question combined with Celerra:
Is it right to put these < TAG > at the end of line like in the example for the trap.cfg
snmpmanager 126.96.36.199 ; communityname public <tag></tag>
thx for feedback
i did the whole process another time, same result. Nothing.
Process i followed:
Downloade the file from EnVision Site: enVision_eventv5_6.cfg
put the file enVision_eventv5_6.cfg into the folder
edited the file /nas/site/trap.cfg
snmpmanager 10.x.x.x ; communityname public <tag></tag>
executed follwoing commands.
nas_event -Load /nas/site/enVision_eventv5_6.cfg
/sbin/chkconfig --level 2 snmpd on
/sbin/chkconfig --level 3 snmpd on
/sbin/chkconfig --level 4 snmpd on
/sbin/chkconfig --level 5 snmpd on
tcpdump -i eth3 dst port 162 ( no message's ... )
should i do anything else?(does the manual forget somthing?)