Re-image v10.6 process failure after boot
Few days back I was trying to re-image one appliance to Pack Hybrid on v10.6, I followed all the proper steps mentioned in the attached document to re-image an appliance, but at the end of the process it's showing me error related to some packages failure, I would request you to kindly have a look at the screenshot no. 1 which is being attached to this discussion and at the end when the error was not moving to any other page after more than 10 minutes so then I forcefully restart the appliance and after the appliance boots up it started showing me some different error (attached as screenshot no. 2).
I am also attaching the document which I properly followed to re-image the appliance.
Pls advise if someone had faced the same kind of issue earlier before, your valuable points would really help me a lot.
The article is correct and should work fine. Try re-imaging again and if it fails for any reason with the same error, then probably the ISO is corrupted and you might need another ISO image to try with.
Yes, agreed with Khaled. Please download the image once again from Download Central but do the checksum after download.
It is recommended, proper checksum required if you download any big size file.
Hi, I face the same problem and the workaround is to load the iso by IDRAC, otherwise If you used an usb did you make bootable only with iso image? did you paste BOOT directory from sainstall-10.X.X.X-usbboot.iso to usb?, hope this helps.