Appliance 250 nominal power and airflow?

[AdibahMohdShah]

Hi all,

Does anyone know the answers to the following technical specs of the RSA SecurID Hardware Appliance 250?

• Nominal Power
• Airflow: Is it a front-to-back cooling?

I've searched through the 'EMC® SVR-I1U-1208 Server Installation and Maintenance Guide', downloaded from here: https://community.rsa.com/docs/DOC-45077 , but I don't think it's stated there (unless i've mistakenly missed it).

Many thanks!

Regards,

Adibah

[EdwardDavis · Accepted solution]

For the Intel 250

Yes, front to back.

Six dual rotor managed system fans

One power supply fan for each installed power supply module

Power supply: Two 750W Platinum (1+1) Redundant Hot-swap Capable

     Power Supply Specification:

Wattage	750W (Energy Smart)
Voltage	90 – 264 VAC, auto-ranging, 47 Hz-63 Hz
Heat Dissipation	2560 BTU/hr
Maximum Inrush Current	Under typical line conditions and over the entire system ambient operating range, the inrush current may reach 55 A per power supply for up to 5ms
80 Plus rating	Platinum
Climate Saver (CS) rating	Platinum

Temperature
Operating	10° to 35°C (50° to 95°F) with a maximum rate of change not to exceed 10°C  per hour
Non-Operating	-40° to 65°C (-40° to 149°F)

[AdibahMohdShah]

Hi Edward,

Thank you for your response. May I ask if you could share with me the documentation / guide (if any) that contains the specs that you have listed above?

Thank you.

Regards,

Adibah