Hello, I have a Terminal Server running Windows 2012 R2.
We have installed and configured RSA Authentication Agent and it works. However when users login they get this screen:
And they have to press the arrow and then choose RSA.
We would like to see the RSA login first, so our users don't have to press the arrow and then choose RSA.
Is this possible? How to setup?
Thanks!
Regards Roald Amundsen
Hello Ronald,
Please check the below
Change the credential provider settings using gpedit.msc
1. Start --- > Run --- > gpedit.msc
2. Expand Administrative templates
3. Expand Classic Administrative templates
4. RSA Desktop --- > Credential provider Filter Settings:
The following 4 changes have been made:
Exclude the Microsoft Password Credential Provider =Enabled
Exclude the RSA Credential Provider for disconnect auth =Disabled
Exclude the RSA Smart Card Credential Provider =Disabled
Exclude the Third-party Credential Providers = Enabled
5. Command line prompt: gpupdate /force
6. Log off and log back.
So kindly check and advise us back if there is any assistance needed from our side.
Best Regards,
That worked, thanks!
Hello Ronald,
Please check the below
Change the credential provider settings using gpedit.msc
1. Start --- > Run --- > gpedit.msc
2. Expand Administrative templates
3. Expand Classic Administrative templates
4. RSA Desktop --- > Credential provider Filter Settings:
The following 4 changes have been made:
Exclude the Microsoft Password Credential Provider =Enabled
Exclude the RSA Credential Provider for disconnect auth =Disabled
Exclude the RSA Smart Card Credential Provider =Disabled
Exclude the Third-party Credential Providers = Enabled
5. Command line prompt: gpupdate /force
6. Log off and log back.
So kindly check and advise us back if there is any assistance needed from our side.
Best Regards,