I have created an AFX connector and was going to bind it to a directory and Role Set. However, when I attempt to edit AFX Connection Binding the Connector drop-down is empty. What might be a reason for it and how do I diagnose this issue?
Thanks,
-aaron
Hi Aaron,
My guess is that the connector is currently in "Test" state - it needs to be in "Active" state in order to show up in the Directory and Application connector binding drop-down.
To change the state, you can edit the connector and change the State on the General tab.
Hope that helps,
Cory
Cory,
That was it, the test state. Thanks a bunch!
Best regards,
-Aaron
—
Aaron Stromas | RSA The Security Division of EMC | Practice Consultant | Identity & Fraud Protection Practice | M +1 240 271 64 58 |
on Sep 6, 2016
Hi Aaron,
My guess is that the connector is currently in "Test" state - it needs to be in "Active" state in order to show up in the Directory and Application connector binding drop-down.
To change the state, you can edit the connector and change the State on the General tab.
Hope that helps,
Cory