Hi All,
We are using RSA G & L 7.0.1, with Remote DB setup. Initally the AFX server was working fine during the first install. Once the AFX server went down, so we re-installed it again. From that point the AFX application is not starting.
Please note: We have changed the client.keystore and server.keystore and also tried with the fresh AFX Server archive download file too. Still the AFX is not working.
Anyone can guide on this please?
Thank you.
Regards,
Vivek
I had the same thing happen to me when I upgraded to 7.0.1 from 7.0. I don't know if that's the case with you but the certificate for AFX is now in a different place than 7.0.
In any case, copy client.keystore to the AFX server under <AFX-server-root>/esb/conf. (mule/conf in versions before 7.0.1)
Hi Andrew,
Please find the AFX-INIT and AFX-MAIN log file snap shot attached.
Thank you.
See these two KB articles and make sure you have tried the steps:
https://community.rsa.com/docs/DOC-47324
https://community.rsa.com/docs/DOC-49615
I've had similar issues- there's basically 3 different processes that run when you start up AFX-
1) core enterprise service bus (this is what actually hosts the code that AFX executes)
2) MMC console (this is what reports connector/server status back to the UI)
3) ActiveMQ (facilitates the messaging process of the esb)
In your case, it looks like #2 didn't start. I've seen a few reasons for this- usually it's some sort of port conflict. By default it's supposed to use port 7777. Perhaps there's something else on the box using it? I'm a little doubtful since it used to work- but that's another area to check.
See these two KB articles and make sure you have tried the steps:
https://community.rsa.com/docs/DOC-47324
https://community.rsa.com/docs/DOC-49615