Guys please help,we recently bought two new units to replace our current appliances,currently we have 1 x primary Securid 130 appliance and 1 x replica appliance in our DR site both run on different networks/subsets , I have replaced the replica already by taking it offline/removing it and took it out of the configuration and then just setup the new unit as a new replica...but now I need to replace the primary unit and am unsure as to how to go about it....
can I just switch off the primary and remove it from the configuration and setup anew primary ....PLEASE help and if possible list the correct steps for me to take
Thank you
You did not say what version of Authentication Manager you are running, but in general you can deploy a new replica to a primary within some range of the same version, just not between 8.2 and any previous version, e.g. 8.1 SP1. So if you have already "setup the new unit as a new replica" I assume it is a replica of the primary you want to eliminate, therefore I suggest you promote the current new replica, eliminate or remove the old primary if it was online during this promotion (promotion for maintenance) and "setup the [second] new unit as a new replica" to the recently promoted primary.
The other option is to take a backup from 1 primary and setup a new primary, then restore the backup to the new primary. But if you do this, the replica that you have already done will not attach to this new primary, you will have to factory reset it and deploy it again.