Anyone else have this issue? Clicking and dragging on the icons doesn't do anything.
Version: 7.1.1.162856 P01
Permissions: Aveska System Administrator
Anyone else have this issue? Clicking and dragging on the icons doesn't do anything.
Version: 7.1.1.162856 P01
Permissions: Aveska System Administrator
Can you further explain what you are trying to do, perhaps with some screenshots?
If you are trying to add a new node to your workflow, then you just single left-click the required node icon from the left-side panel then double left-click anywhere in the middle area to add that node.
Hi Mostafa,
Thank you for the quick reply. That was the problem, I guess the article I was referencing has outdated information.
RSA IGL Services 101: Explaining Workflow Nodes - "Create Admin Error" under Configuration
"Create Admin Error nodes are found under the "Modeler Toolbox", about halfway down, as shown in the image below. Just drag and drop them into your workflow"
I could be misinterpreting what you are describing but I am not aware of any such issue with WorkPoint.
Is WorkPoint otherwise functioning correctly?
Can you further explain what you are trying to do, perhaps with some screenshots?
If you are trying to add a new node to your workflow, then you just single left-click the required node icon from the left-side panel then double left-click anywhere in the middle area to add that node.