RSA Admin

Certificate error when setting up Checkpoint box

Discussion created by RSA Admin Employee on Aug 13, 2008
Latest reply on Oct 9, 2009 by 2QFL3LymIB6xwL5Uy73QZVQtt0E2S9rpdhju7K8M9jQ=

Hey folks,

I'm trying to add a new Checkpoint box to report into our Envision setup.  We decided to go with SSLCA authentication, so I made it to the point where the following command needs to be run from the LC:


OPSEC_pull_cert –h –p password –n enVision_OPSEC


However, after running that command, I get the following error:


Opsec error. rc=-1 err=-93 The referred entity does not exist in the Certificate Authority.


 I was able to add a second Checkpoint box fine using this same method, but for some reason, this particular one is being troublesome.

Any ideas as to what could be causing this error?