How to change RSA ACE/Server password when in Change Required mode
Originally Published: 2000-09-07
Article Number
Applies To
RSA ACE/Server Passwords
Issue
Password Enabled; Change Required
New PIN mode
Resolution
1. $ ./sdshell
2. Enter PASSCODE: (this is where you enter your initial password requiring change)
3. Enter your new PIN, containing 4 to 8 characters
or
<Ctrl D> to cancel the New PIN procedure
4. Enter your new password. This can be the same as the old password. You see the message:
Please re-enter new PIN:
5. Re-enter the new password
6. Wait for the code on your token to change, then log in with the new PIN. You see the message:
Enter PASSCODE:
7. Enter the new Password again (you do not have to wait before re-entering it). You see the message:
PASSCODE Accepted
$
NOTE: The message "Enter your new PIN" can sometimes be confusing. Users may think they are setting a PIN, when they are only using the PIN to log in.
Related Articles
Which ports need to be opened between the Domain Controller and Thor Xellerate server for password synchronization? Number of Views Change Your Account Name and Password in the Cloud Administration Console Number of Views Change the Identity Router Administrator Password Using the Identity Router Setup Console Number of Views How to configure more than two IP addresses for an RSA Authentication Manager 8.2 Web Tier Virtual Host Number of Views How to change the AveksaAdmin password in RSA Identity Governance & Lifecycle Number of Views
Don't see what you're looking for?
