Connecting Agent ID Secure
Last Modified: 2026-11-19

Connecting Agent ID Secure

You can connect Agent ID to Agent ID Secure. It reads the registry of the tenant you are signed in to and surfaces runtime agents, MCP servers, and the relationships that the gateway observes between them.

Unlike other connectors, there are no credentials to enter. Discovery reads the registry of your own tenant with its own key, so you do not create an application, a secret, or a certificate.

Before you begin 

Ensure you have the following:

Requirement

Details

Agent ID Secure licenseA license for this tenant. Without one, Test Connection fails and reports that the license is missing.
Gateway registry APIThe gateway's registry API must be configured where Discovery is deployed. Until it is, a saved connection reports an error.

Agent ID Setup

Procedure 

  1. On the Connectors page, click Add source.
  2. In the Add a source dialog, locate Agent ID Secure and click Connect on the Agent ID Secure card.
  3. Type a Connection name and choose a Scan frequency.
  4. Click Test Connection, confirm it succeeds, then save the connector.

No credentials are entered.

Troubleshooting

  • Test Connection fails and reports a missing license.

    The tenant does not have an Agent ID Secure license. Obtain a license for this tenant, and then test the connection again.

  • A saved connection reports an error.

    The gateway's registry API is not yet configured where Discovery is deployed. Configure it, and then test the connection again.