Using the setpin utility on a replica.
Originally Published: 2002-06-20
Last Modified: 2023-09-25
Article Number
Applies To
Sun Solaris
Microsoft Windows 2000
Microsoft Windows NT 4.0
HP-UX
IBM AIX
Issue
The setpin utility can be run on a replica
Cause
Resolution
The setpin program should only be used on the primary ACE/Server; a patch is available on request if customers wish to ensure they are not able to run it on a replica. This functionality has been disabled by patch tst00028343 and has been incorporated into patch 3. Customers should either install patch3 or upgrade to ACE/Server 5.1 to correct this.
Related Articles
Promote a Replica Instance Using Promotion for Maintenance Number of Views Using the RSA Authentication Manager Migration Assessment Utility to upgrade from RSA Authentication Manager 6.1 to 8.1 Number of Views How to Synchronize RSA SecurID Tokens in RSA Authentication Manager 8.x Using the sync-tokens Utility Number of Views How to factory reset an RSA SecurID hardware appliance running Authentication Manager 8.2 without using the installation I… Number of Views Quick Setup of a Replica Instance fails the attach to the Primary Instance Number of Views
Trending Articles
How to manipulate imported RSA SecurID Software Token(s) on an iPhone or iPad device Manual synchronization introduced in RSA Authentication Manager 8.2 Service Pack 1 patch 6 Quick Setup Guide - Passwordless Authentication in Windows MFA Agent for Active Directory How to verify NTP server synchronization is not working in RSA Authentication Manager 8.x RSA Governance & Lifecycle 8.0.0 Installation Guide
Don't see what you're looking for?
