Command in RSA Authentication Manager (AM) 8.X to set the run level for the NTP service on boot.
Originally Published: 2014-06-05
Article Number
Applies To
In RSA Authentication Manager (AM) 8.X, sudo to root, then run the folowing command:
/sbin/chkconfig --level 2345 ntp on
Issue
Resolution
In Auth Manager 7.1 and the RSA SecurID Appliance 3.0, the steps to set the run level of NTP were to sudo to root then run the following command:
/sbin/chkconfig --levels 2345 ntpd on
Related Articles
Weblogic will not start 'User weblogic is not permitted to boot the server' Number of Views RSA SecurID Appliance hangs when booting on NTP service for RSA Authentication Manager 8.1 Number of Views Memory/battery problems were detected error and boot process is stuck during boot of Dell-based or Intel-based RSA SecurID… Number of Views RSA Authentication Manager server fails to boot starting Dracut Emergency shell Number of Views Troubleshooting NTP errors on an RSA Authentication Manager 8.x appliance Number of Views
Trending Articles
RSA MFA Agent 2.3.6 for Microsoft Windows Installation and Administration Guide RSA Authentication Manager 8.9 Release Notes (January 2026) How to install the jTDS JDBC driver on WildFly for use with Data Collections in RSA Identity Governance & Lifecycle RSA Authentication Manager 8.8 Setup and Configuration Guide Artifacts to gather in RSA Identity Governance & Lifecycle
Don't see what you're looking for?
